weberprim aqua seal

Product formerly named: BELCEM AQUA SEAL
water repellent, natural stone

ready-to-use, transparent, thin liquid, solvent type, silicone-based impregnator for use in the protective treatment of Natural Stones, Selected Ceramic & Clay Tiles, Cementitious Substrate etc.

1, 5, 20 Ltr / steel drum

Documentation and brochures

To know before applying

  • weberprim aqua seal is supplied ready-to-use. No further dilution is required. Stir well before use.
  • Preliminary testing on small trial areas is important to determine coverage and compatibility of weberprim aqua seal with materials to be treated.
  • Natural Stone Slabs (& other materials) to be treated must be dry, sound and free of contamination eg. grease, oil, dust, laitance etc.
  • Do not apply on damp or wet surfaces and during wet weather conditions.
  • Apply weberprim aquaseal to the Underside & Edges (4 sides). It can also be applied to the Top Surface, if slight colour enhancement is acceptable.
  • Apply weberprim aqua seal evenly with a brush, roller or cloth Ensure that thin even coats are applied; rather than thick or lumpy coats.
  • weberprim aqua seal can be applied as a single coat protective treatment. However more often than not, certain materials may require two (2) or more coats of treatments for effective water repellent result.
  • It is advisable to check porosity of material to be treated to determine the number of treatment coats required. Generally, low porosity (dense) material would normally require 1 - 2 coats
    of treatment; however porous material may require two (2) or more treatment coats.
  • Where a Second Coat is required, allow First Coat to impregnate into the Natural Stone Slab, usually within 30 - 60 minutes,before applying the Second Coat in similar fashion. The timing will vary dependant on porosity or texture of materials to be treated, weather or atmospheric condition etc. Repeat similarly should additional treatment coats are required.
  • The Second Coat (Subsequent Coat) must be applied wet on wet; before First Coat (Preceding Coat) dries out or fully cure.

Consumption is not availble, please have a look at the PDF documentation

Features and benefits

  • Water repellent protection
  • Application for top, edge & bottom surface
  • Creates an easy cleaning surface

Constraints

  • weberprim aqua seal is solvent-based; therefore apply in areas with good cross ventilation. It is flammable; therefore avoid contact with open fire or sources of ignition during application.
  • Staining or discoloration of Natural Stone Slabs arising from oxidation within the Natural Stone Slab cannot be prevented with treatment of weberprim aqua seal.
  • It is the responsibility of users / applicators to determine condition and suitability of all surfaces; prior to actual application.