E.MIX Eco Base

Substrate Preparation

• Remove dust, loose particles, grease and traces of foreign materials that may affect adhesion
• Dampen the dry absorbent surface before application of E.MIX Eco Base

Mixing & Installation

• Mix thoroughly with appropriate amount of water by using an electrical mixer.
• Mixing time is 3 - 5 minutes.
• Allow mixture to stand for 10 minutes for additives to dissolve.
• stir again the mixture and ready to apply
• Apply with steel trowel or spatula
• When applying several layers, the layer underneath must be dried before spreading the subsequent layer.

• Easy to apply
• Good bond strength
• Provides flat surface

• Recommend to wear NIOSH approved or equivalent face mask when mixing procedures
• Material contains cement, which may produce an allergic effect
• Material may cause irritation to eyes and skin. If contact with eyes and skin rinse immediately with water and seek medical assistance.