webermix GT mix I
4, 25 Ltr
ready to use, Water-Based Emulsion Polymer, specially formulated for use with weber’s range of Cement-Based Coloured Grout (ie. weberfill fine grout, weberfill F&W grout & weberfloor flooring grout).
-
As some solid matter in webermix GT mix I may settle during storage, it is essential to stir well before use in temperature lower than 4°C
-
Allow adhesive bed to set, usually 24 – 48 hours before grouting commences. Joints must be dry and free of contaminants ie. Loose particles, dust, laitance etc
-
webermix GT mix I is ready to use; therefore does not require further addition of water
-
Cement-based grout modified with webermix GT mix I, should be applied in the normal approved procedure (similar as when mixed with water only)
-
Apply grout to small areas at a time & completely fill the joints with a rubber squeegee or grout float
-
The working time (pot life) of grout modified with webermix GT mix I may be reduced slightly. The drying time may also be shorter, particularly where higher concentration of admixture is used.
-
The finish colour shade of cement-based grout mix with water may not be similar compared to those mixed with webermix GT mix I.
-
For uniform colour, ensure that the same mix proportions is used throughout the installation
- For use at dry or wet areas, internal or external areas including areas
under immersion of water (swimming pool, water tank etc.) - Increased Durability
- Reduced Water Permeability
- Imparts Flexibility
- Greater Adhesion
Minimize Growth of Fungus & Algae
-
Colour pigments in coloured grout may stain or discolor certain tiles or natural stone slabs; therefore a trial should be conducted to determine ease of cleaning and compatibility
